Axle Load Sensor Eurosens DDS A
Overview
It continuously transmits the position data to a server. height sensors, Truck height sensor, leaf type sensor
Eurosens DDS converts the angle of rotation of the sensor’s lever to output signal. As the transducer is used magnetoresistive sensor.At the output of the sensor is formed stabilized analog voltage signal, which corresponds to the angular position of the pivot arm, changing depending on the load on the axle vehicle.
Eurosens DDS A output voltage:
| Rotation angle, degrees | Output voltage, V |
| – 40 | 1,54 |
| – 30 | 1,78 |
| – 20 | 2,02 |
| – 10 | 2,26 |
| 0 | 2,50 |
| 10 | 2,74 |
| 20 | 2,98 |
| 30 | 3,22 |
| 40 | 3,46 |
Eurosens DDS 485 uses LLS/MODBUS protocol. Eurosens DDS CAN uses CAN bus J1939 protocol with configurable PGN. After installation and wiring Eurosens DDS you should perform a calibration in which you are mapping the output voltage to the load on the suspension of the vehicle.
Need help choosing the right product?
Our team helps you spec the right hardware for your fleet or site — no guesswork.


